![]() Where your main router (and presumeably your gateway) have the address 10.1.1. Plug in the UART cable and attach to the UART. Put the SD-card back into the Raspberry Pi 3. Those details (assuming we will use the 10.1.1.11 IP address) should look like the following # Custom static IP address for wlan1. You need to figure out and replace that with the correct name (s) for your computer and SD-card (typically run dmesg and look for the device name matching your SD-card). This time add the details for the wlan1 connection to the end of the file. If you want to make the wlan1 IP address static edit the /etc/nf file with the command… sudo nano /etc/nf So long as your usb dongle has been recognized automagically at the start (which you indicated it was) you should now be able to use wlan1 at the IP address 10.1.1.11. This increases speed of file transfer and enhances privacy of your files by not storing them on 3rd party servers. TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 GoodSync Connect allows users to connect two computers directly, in a peer-to-peer fashion, without using intermediate servers to store files. RX errors 0 dropped 20 overruns 0 frame 0 ![]() ![]() There are various tutorials on how to do this in the Pi 2, but none on the Pi 3 since it has a built-in wifi adapter. Inet6 fe80::1cee:e236:9bda:2be8 prefixlen 64 scopeid 0x20Įther b8:27:eb:b6:2e:da txqueuelen 1000 (Ethernet) I have a Raspberry Pi 3 with Stretch and wish to install a Realtek USB WLAN adapter. This should show all the configured connections eth0: flags=41 Once we have rebooted, we can check the status of our network interfaces by typing in ifconfig To allow the changes to become operative we can type in sudo reboot (The country=NZ line will probably indicate a different country depending on what you have set up as your localisation configuration.) Here so that the file looks as follows (using your ssid and password of course) country=NZĬtrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev If you are comfortable having a dynamic address set by the local DHCP provider (ADSL modem or similar) you should be able to simply edit wpa_nf sudo nano /etc/wpa_supplicant/wpa_nfĪdd the ssid (the wireless network name) and the password for the WiFi network
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |